Modbus RTU Octal Relay Module RS485 / TTL UART 8 Inputs 8 Outputs Switch Board

Get Modbus RTU Octal Relay Module RS485 / TTL UART 8 Inputs 8 Outputs Switch Board

Feature:

1. Onboard mature and stable STM8S103K3T6 MCU and MAX485 level conversion chip

2. Communication protocol: support standard Modbus RTU protocol

3. Communication interface: support TTL UART interface with RS485 / 5V level

4. Communication baud rate: 4800/9600/19200, default 9600bps, support to save after power off

5. The signal range of optocoupler input: DC3.3-30V (this input cannot be used for relay control)

6. Output signal: relay switch signal, support manual, flash off, flash off mode, flash off / flash delay base is 0.1S, maximum flash off / flash time can be set to OxFFFF * 0.1S = 6553.5S

7. Device address: range 1-255, default 255, support to save after power off

8. Baud rate, input signal, relay status, device address can be read using software / command

9. On-board 8-channel 5V, 10A / 250v AC, 10A / 30vDC relay, which can be continuously attracted 100,000 times, with diode bleed protection, short response time

10. Onboard relay switch indicator

11. STM8 SWIM program is reserved for programming, supporting customers to download their own firmware for secondary development

12. Power supply voltage: DC7-30V, 5.08mm terminal power supply

Package includes:

1 x Realy board

1. VCC, GND: DC7-30V 5.08mm power input terminal

2. DC3.3-30V optocoupler signal input:

IN1-IN8: Positive channel 1-8

GND_IN: Channel 1-8 common negative

3. A+, B-: RS485 communication interface, A +, B- are connected to A +, B- of external control terminal respectively

4. 5V, SWIM, GND, NRST: STM8 SWIM program download port

5. TXD, RXD, GND: TTL level UART communication interface, TXD, RXD, GND are connected to RXD, TXD, GND of the external control terminal, only support 5V level TTL module / MCU. Use wiring order suggestion: Modbus Power-Modbus module connects to TTL module-TTL module is powered on

6. RST: MCU reset button

7. Relay switch signal output:

NO: Normally open, the relay hangs before pull-in, short-circuit with COM after pull-in

COM: Common

NC: Normally closed end, the relay is short-circuited with COM before pull-in, and hangs up after pull-in

Modbus RTU Octal Relay Module RS485 / TTL UART 8 Inputs 8 Outputs Switch Board See detail